NeoFlex-M-Schnitt

Owner’s manual for Alto-Extremo equipment feet

Dear audio enthusiast,

Thank you for your decision to purchase the products of Alto-Extremo.
Our products are manufactured to the highest degree of quality.
The Alto-Extremo products have been designed for reliable operation with your devices. The operational safety is important to us, therefore the stop rings were developed.
Please take a moment to read this owner´s manual to ensure correct set up, which will give you many years of musical enjoyment and pleasure.

General Information
•Maintain a stable surface
•Set the device feet to the corners of the unit to prevent tipping
•The thread (Lyd I, Lyd II and Exact) is for mounting directly under loudspeakers and hifi-devices. Please don’t place any absorber directly under spikes or serial device feet. Please use absorber in addition (beside) the serial feet or spikes, or change the serial feet with the absorbers
•Classic and NeoFlex have no mounting thread. These feet are placed directly under your hifi-devices
•You can use three or four equipment feet. It depends on the dimensions of the hifi-device or loudspeaker, the load capacity of the equipment feet and their own preference. Both options working as well.

Lyd I and Lyd II additional information
The outer (blue) damping ring is for vibration minimalizing. Try the absorber with the damping ring side to the ground and you minimize vibrations from the device and disconnect the ground. If you use the absorber with the damping ring side to the device you disconnect the device and minimize vibrations from the ground. Some equipment should be disconnected, some connected. You have two ways to find your prefer sound.
The adjustable puck compensates for uneven floor surfaces. The inner component is flexible. They can tilt to the side, if the floor is uneven. If you have an older wooden floor or an uneven tile ground, the lyd can compensate that. That's no height adjustment. The inner component from the lyd is sometimes a little bit tight. So you need a little bit more strength to tilt to the side.

Exact additional Information
The adjustable puck compensates for uneven floor surfaces. The inner component is flexible. They can tilt to the side, if the floor is uneven. If you have an older wooden floor or an uneven tile ground, the Exact can compensate that. That's no height adjustment.

Neo-Flex additional Information
Operating instructions:
With the central screw under the absorber, the (right) groove can be adjusted. By using this screw the lower Neodym magnet can be set. If you bring the magnets closer together you can increase the absorber’s load capacity.
The outer (blue) damping ring is for vibration minimalizing. Try the absorber with the damping ring side to the ground and you minimize vibrations from the device and disconnect the ground. If you use the absorber with the damping ring side to the device you disconnect the device and minimize vibrations from the ground. Some equipment should be disconnected, some connected. In this way it is possible to further optimize the absorbers.
NeoFlex-L-unten
Please make note of the following when working with Neodym magnets:
The magnets should not be used near pacemakers, magnetic data storage devices and monitors. Take care not to pinch your skin with the magnets. Do not allow the magnets to smash together as this can cause them to chip. We are not liable for any damage that results from improper use of the magnets. The NeoFlex absorber has a magnet cap, so they can place under each high end devices.

Alto-Extremo
Tulpenstraße 9b
45772 Marl-Germany
Mail: info@alto-extremo.com

Impressum       AGB

english